Elem Garden Technic THB20V-LI2AF, Translation Of The Original Instruction, Page: 75 / 92

Mounting the front handle
Note: It is possible that the front handle is already
attached to the grass trimmer. However, the
following instructions detail its installation in full.
1. Press on the adjustment buttons on both sides of
the front handle.
2. While pressing on the buttons, slide the handle
onto the handle support located on the shaft. (Once
the front handle is in place, release the buttons)
To adjust: Press on the adjustment buttons on the
front handle.
The support for the front handle can be raised or
lowered on the shaft and the front handle itself can
be moved back and forth through 5 different
blocking positions when the adjustment buttons are
pressed. Lock by releasing the buttons, to fix the
handle at the desired height.
OPERATION
Starting up
▪
To switch on the grass cutter, press the On/Off
button. To switch it off, release the On/Off button.
▪
If you find that the nylon line is too short, allow the
grass cutter to run for a few seconds while touching
the work area, in order to let it cut the line one it has
lengthened.
▪
Do not overload the grass cutter. Cut in small
sections at a time; this will considerably improve the
efficiency of the grass cutter, which will therefore
function at high speed.
▪
When you cut lawn close to fences, walls, etc., use
the edge of the safety shield as a guide.
Adjusting the telescopic shaft
To adjust the telescopic shaft, loosen the blocking
collar and slide the shaft elements to the desired
height.
Tighten the collar to block the shaft at the desired
length.
SMART LINE FEEDING
WARNING: Deactivate and
remove the battery from the
appliance before
cleaning or making any
adjustments!
When switching on the grass cutter for the first time,
a short length of line is unspooled. When the line
hits the line-cutter, a rattling sound will be made. DO
NOT WORRY.
This phenomenon is normal. After 5 seconds, the
line is cut to the correct length and the noise will