23
– Never touch the mains plug with wet
hands.
f Do not run over, crush or pull the
power supply cable or extension lead,
otherwise it may be damaged. Protect
the cable from heat, oil and sharp
edges.
– The extension lead must have a
cross section in accordance with the
operating instructions and be protected
against splashed water. The
connection must not be in water.
– Always wear gardening gloves when
handling
or working near the sharp tines/blade.
INTENDED USE
This product is intended for domestic, lawn rak-
ing, scarifying or verticutting of lawn.
ASSEMBLY
For Your Safety
_
Warning! Switch off, remove plug from
mains before adjusting, cleaning or if cable
is cut, damaged or entangled.
_
The tines/blades continue to rotate for a
few seconds after the machine is switched
off.
_
Caution
– do not touch rotating
tines/blades.
_
Always wear gardening gloves when han-
dling or working near the sharp tines/blade.
Electrical Safety
Your machine is double insulated for safety and
requires no earth connection. The operating
voltage is 230 V AC, 50 Hz (for non-EU countries
220 V, 240 V as applicable). Only use approved
extension cables. Contact your ELEM GARDEN
TECHNIC Service Centre for details :
Extension cords/leads should only be used if
they comply with H05VV-F, H05RN-F types or
IEC type design (60227 IEC 53, 60245 IEC 57).
If you want to use an extension cable when op-
erating your product, only the following cable di-
mensions should be used:
– 1.0 mm²: max. length 40 m
– 1.5 mm²: max. length 60 m
– 2.5 mm²: max. length 100 m
Note: If an extension cable is used it must be
earthed and connected through the plug to the
earth cable of your supply network in accord-
ance with prescribed safety regulations.
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and sock-
et must be of watertight construction and in-
tended for outdoor use.
Cable connections should be kept dry and off
ground.
It is recommended for increased electrical safe-
ty to use a Residual Current Device (RCD) with
a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
Assembly
ATTENTION !
Disconnect the power plug before
carrying out any
adjustments or maintenance.
_
Ensure the cables are not trapped when
folding/unfolding top/bottom handles. Do
not drop the handles.
Some parts of the scarifier have been dismantled for
transport purpose. The screws, handwheels, cable
clips, cable hook, screwdrivers and spanner are to
be found in plastic bags.
Assembly is simple if you follow these instructions :
Assembling bottom handle part
Insert securing screw (A) form inside through the left
side element. Position insulation element (B) from
outside; the two nubs must catch in the holes of the
side element (2). Place insulating element (B) so
that the large opening points to the outside.
Position tip of handle element (N) in the insulating
element (B).
Then tighten wing nut (H).
Summary of Contents for SCEE12002B
Page 2: ...2 1 2 A B 3 4 5 6 7 8 7...
Page 36: ...36...
