GB / WOOD SPLITTER
FB1500-5TEG52STAND
WARNING
Read this manual carefully before using the
machine, for your own safety.
SAFETY INSTRUCTIONS
When using the machine, always observe the
enclosed safety instructions as well as the additional
safety instructions.
ADDITIONAL SAFETY INSTRUCTIONS FOR
WOOD SPLITTERS
Wood splitters must not be used by children or
untrained persons.
Before use, always check the condition of the
splitting mechanism. Do not use the appliance when
the splitting mechanism is worn.
Keep body parts away from the splitting wedge.
Never attempt to move the appliance during use.
Prevent the splitting mechanism from touching
hard objects during use.
Always split logs in the direction of the grain only.
Always split logs one at a time.
Do not use a hammer or an axe to remove
clamped logs from the splitting wedge.
Do not use strange packing blocks between the
pressure cam and a log.
Only use the machine in daylight or with good
lighting.
During use, always keep your hands and feet
away from the splitting wedge.
Do not step over or straddle the appliance during
operation.
Never reach or bend over the appliance to pick up
logs.
Never attempt to load the appliance when it is in
motion.
Never attempt to split extremely small logs.
Make sure that the mains cable does not touch
the splitting wedge.
Only switch off the appliance when it runs at no
load.
Immediately switch off the appliance if it jams
during operation.
Make sure that the pressure cam is in the rest
position before transporting or storing the appliance.
Hydraulic oil may cause a severe health risk. Avoid
skin contact with hydraulic oil.
ELECTRICAL SAFETY
Always check that the power supply corresponds to
the voltage on the rating plate.
DESCRIPTION
Your wood splitter has been designed for splitting
logs.
1. Oil Tank
2. Log Pusher
3. Work Table
4. Wedge
5. Lift Handle
6. Support Leg
7. Work Table Extension w/ Log Retaining
Plates
8. Switch
9. Motor
10. Pushbutton Box
11. Wheels for Minor Moving ONLY.
12. Lift Handle
13. Hydraulic Control Lever
14. Control Lever Guard
15. Bleed Screw
16. Oil Drain Bolt w/ Dipstick
17. Max Pressure Limiting Screw
DO NOT ADJUST THE MAX PRESSURE
LIMITING SCREW !
INSTRUCTIONS FOR USE
Check that the hydraulic system is vented before
first use.
Check the oil level.
Place the appliance on a level surface or on a
sturdy table.
Place a log in a straight line against the splitting
wedge.
Move the pressure cam toward the splitting
wedge until the log splits.
Move the cam back to its rest position.
Remove the log.
OPERATING THE PRESSURE CAM
To move the cam (3) forward, push the on/off
switch (1) and subsequently push the handle (2)
down.
To move the cam backward, release the on/off
switch and subsequently release the handle.
To stop the cam, release the on/off switch.
CLEANING AND MAINTENANCE
Regularly clean the ventilation slots.
Clean the outside of the appliance with a moist
cloth.
Regularly check the appliance for possible
damages and leakage.
VENTING THE HYDRAULIC SYSTEM
The hydraulic system must be vented before first
use and after changing the oil.
Loosen the plug (8) a few turns.
Wait until the system has been vented.
Tighten the plug.
