1
Troubleshooting
PROBLEM
CAUSE
ACTION
The motor does not run
Safety lock.
Tighten the hand screw firmly.
Power failure.
Tighten the hand screw firmly.
The material to be chopped is
not drawn in
The material is jammed in the feeding
funnel.
Switch the shredder OFF.
Pull the material from the feed funnel.
Switch the shredder back ON and refeed
thick branches such that the blade does
not immediately engage the
pre-cut notches again.
Shredding material is too soft.
Insert wood or shred dried branches.
The cutting blade is blocked.
Loosen the hand screw, open the
shredder and remove the material that
causes the blockage.
SERVICE DEPARTMENT
_ Damaged switches must be replaced by our after-sales
service department.
_
If replacing the power cord is necessary, it should be
done by the manufacturer or his agent to avoid a hazard.
After-sales Service and Application Service
Our after-sales service responds to your questions
concerning maintenance and repair of your product as well as
spare parts. Exploded views and information on spare parts
can also be found under:
www.eco-repa.com
ELEM GARDEN TECHNIC application service team will
gladly answer questions concerning our products and their
accessories : sav@eco-repa.com
STORAGE
_ Thoroughly clean the whole machine and its accessories.
_ Store it out of the reach of children, in a stable and secure
position, in a cool and dry place, avoid too high and too low
temperatures.
_ Protect it from exposure to direct sunlight. Keep it in the
dark, if possible.
_ Don’t keep it in plastic bags to avoid humidity build-up.
GUARANTEE
Refer to the enclosed guarantee conditionsfor the terms and
conditions of guarantee.
ENVIRONMENT
Should your machine need replacement
after extended use, do not put it in the
domestic waste but dispose of it in an
environmentally safe way.
ELEM GARDEN TECHNIC
81, rue de gozée
6110 Montigny-le-Tilleul
Belgique
Tél : 0032 (0) 71 29 70 70
Fax : 0032 (0) 71 29 86
www.eco-repa.com
info@eco-repa.com