INSTALLATION
BPT002 is used for switching the heating device in connection with the
appropriate thermostat.
Fig.1 Fig.2 Fig.3
holes for
installationon
KU/KP68
FUNCTION-
BUTTON
output terminals
Wiring diagram:
power supply terminals
The device can only be installed by a person with adequate
qualification!
The installation must be executed in a voltage-free state!
ACTIVATION PROCEDURE
INDICATION DIODES
1. Lift off the front cover of the receiver acc. to Fig. 1, 2.
2. Attach the receiver to the wall (or to the wiring box directly).
3. Switch off the main circuit breaker.
4. Connect the receiver acc. to the diagram.
5. Connect the receiver to the mains 230 V / 50 Hz.
6. Switch on the main circuit breaker; the green diode flashes on the
receiver; thus the receiver is ready for further setting.
7. On receiver BPT002 shortly press the
FUNCTION BUTTON on for
about 1.5 s
(
the green and red diode are flashing alternately)
.
8. On the thermostat (transmiter) press the button for sendig the code
to activate the receiver - see to the manual for the given transmitter
(thermostat).
9. If the code has been learned correctly, the green and red diodes flash
simultaneously.
Fig.4
FUNCTION BUTTON (R) :
SHORT PRESS
(for about 1.5 s) - for coding.
LONG PRESS
(for about 5 s)- RESET deleting the code
from the memory (the green and red LEDsflash simulta-
neously).
LED 1 LED 2
FUNCTION
empty memory, code not learned
code learned
FLASHING ALTERNATELY = code learning mode
FLASHING SIMULTANEOUSLY = code has been learned
SIMULTANEOUS LONG FLASH= code has been ERASED
relay switched
ERROR
(if no signal is received from the transmit-ter within
approx. 6 hours, it switches to the 2-min-ON / 8-min-OFF
mode). LED 2 is only flashing ifthe relay is on, i.e. for 2
minutes.
EXPLANATIONS: LIT UNLIT FLASHING