18
© 2010, Elektro-Automatik GmbH & Co. KG
EN
About the device
1. General
1.1 Introduction
The microprocessor controlled power supplies of the
PS 800 R series are designed for wall mount and are
cooled by a temperature-controlled fan.
The functionality focuses industrial power supply. The
device will continue operation after a blackout with
the last settings.
The output voltage is seperated into three selectable
ranges, where each one is defined as approximately
1/3 of the nominal voltage.
The power output is short-circuit-proof and overload-
proof. For protection of the loads, the device also
features an overvoltage protection (OVP). During an
overtemperature (OT) event, the power output will
be switched off until the unit has cooled down and
automatically switched on again.
The device require a two-phase supply with 400V for
correct operation.
1.2 Visual check
After receipt, the unit has to be checked for signs of
physical damage. If any damage is found, the unit may
not be operated. Also contact your dealer immediately.
1.3 Scope of delivery
1 x Power supply unit
1 x Printed user manual
2 x Wago plug, 2 pole, plugged
2. Installation
2.1 Mounting
The device is designed for vertical wall mount. It is
required to mount it in a way that allows unimpeded air
flow through the ventilation slots. Take care for plenty
of space (at least 15cm) below and above the device
in order to ensure proper cooling. For the installation
dimensions see section „4. Technical specifications“
and the drawing from page 21 on.
2.2 Mains connection
All models are equipped with an active PFC (power
factor correction) and a wide range input. It can be
operated at AC input voltages from 2x 340V to 460V
and mains frequencies of 50Hz or 60Hz.
The connection is done at the 3pole terminal „Power
Input“ on the top. It must only be carried out by trained
technical personnel. Main focus lies on an appropriate
cross section of the mains lead, as well as the fact
that the device does not feature a power switch. We
recommend to use 2.5mm² (max. 4mm² possible)
leads for these 5kW power supplies.
Input wring scheme from left to right:
L1 (R), L2 (S), PE
It has to be considered that the device does not
feature a mains switch. The AC input is fused by a
standard 5x20mm fuse, type T16A, which is located
in the fuse holder on the top.
2.3 DC output connection
The load is connected to the DC output terminals on
the bottom side, using leads with appropriate cross
section (rec‘d 2.5mm²). The device can produce dan-
gerous voltages. Thus the output must be covered
with the included cover when working with the device.
There are different DC terminal types:
• 80V and 200V
models:
Screw fastening M8 on a plastic DC terminal
Recommendation: ring cable lugs 8mm