elektraLite RGBA Dazer, User Manual, Page: 8 / 15

15. SET.
(Set has several Sub Menus which allow functions to be used).
1).
UPLD.
Custom programs can be uploaded from a master fixture into a slave fixture.
First:- connect the fixtures to power and have a dmx cable going from the Master (dmx out) to the Slave (dmx in).
Second:- using the Master fixture. Go through the Root Menu until
Set
. Press Enter and then use the ↑ or ↓ buttons to get to
UPLD. Press Enter. The display will have 4 dots across the bottom. The password needs to be entered. The password is the
following sequence using the
↑ and ↓ buttons.
↑ ↓ ↑ ↓ press Enter once complete. The upload with start immediately.
The upload average time for transmission is about 30 seconds.
While the upload is in progress the display will be flashing in YELLOW.
Once upload is complete and successful the word END will appear in green
If there is a problem, red will be the color noted.
Several fixtures maybe linked together in the master/slave scenario and programmed simultaneously.
2).
REST
This resets all values to their default.
Go through the Root Menu until
Set
. Press Enter and then use the ↑ or ↓ buttons to get to REST. Press Enter. The display will
have 4 dots across the bottom. The password needs to be entered. The password is the following sequence using the ↑ and
↓ buttons.
↑ ↓ ↑ ↓ press Enter once complete. The display will read OK followed by a return to the REST sub menu. The Menu
button will need pressing to return to the Root Menu. Only once at the Root Menu will the dmx control function. Please note
the Reset also takes the dmx address back to 001.
3).
ID.
ID must be turned ON for it to work from the lighting controller.
So, if in STAG mode you want dmx channel 11 (the ID) to work, it must be turned on in this submenu.
Go through the Root Menu until
ID.
Press Enter and then use the ↑ or ↓ buttons to get to either OFF or ON. Once chosen,
press Enter to save the setting and then Menu to exit out back to the Root Menu.
4).
DIM
The Dim function allows different Dimmer curves to be chosen. There are 5 choices.
Choice 1 :- this is Dim off. The Dimmer curve is 0 which means any change in dimmer level is instantaneous.
Choice 2:- Dim 1. The dimmer curve has the shortest fade in and fade out time.
Choice 3:- Dim 2. The dimmer curve has the 2
nd
shortest fade in and fade out time.
Choice 4:- Dim 3. The dimmer curve has the 3
rd
shortest fade in and fade out time
Choice 5:- Dim 4. The dimmer curve has the longest fade in and the fade out time.
To access the DIM function go through the Root Menu until
DIM
is found. Press Enter and then use the ↑ or ↓ buttons to get to
the DIM choice required.
Please note the DIM function under the Set menu in the fixture does not work when in the STAG mode.
When is STAG mode you can operate/access the DIM function directly through channel 10 on your lighting controller.