2.7
PK 255
Dust collection from chip casing
1. Turn saw upside down.
2. Remove transport support inside the saw hous-
ing.
3. Attach suction port to chipcase with
-
3 ea. hex. head screw M 6x13
-
3 ea. washer
-
3 ea. serrated lock washer
-
3 ea. hexagon nut M 6
3
If you are using a dust collector, connect to
the chip case's suction port.
Dust collection from blade guard
1. Fit blade guard to riving knife.
The lower edge of the blade guard should be in
a horizontal position.
3
If you are using a dust collector, connect the
blade guard's dust spout with the dust collec-
tor as well.
Mitre fence
1. Screw long stud screw into centre tapped hole
of the guide bar and tighten.
2. Screw short stud screw into tapped hole of the
guide bar.
3. Place angle plate on stud screws (short stud
screw into oblong hole).
4. Fit spacer bushing and washer to long stud
screw and screw on the ratchet lock lever.
5. Put large washer on short stud screw and screw
on ratchet lock lever.
6. Fit two cup square neck screws into the fence
extrusion’s groove and put the screw’s threaded
ends though the oblong holes.
7. Fit a washer to each of the screws and screw on
a knurled nut
8. Fit a cup square neck screw into the upper
groove of the fence extrusion and attach the flip
stop as illustrated.
9. Screw extrusion end plates to fence extrusion
as illustrated.
30
45
15
0
15
30
45