User manual Dual DC LISN
150 kHz – 200 MHz |
Assembly of the KIT
After the SMA connectors are shoved through the corresponding holes
place the locking washers and nuts back on the SMA connectors. Push
the PCB evenly a little downwards while tightening the nuts with some
force.
Now the 5 banana sockets can be inserted into the enclosure. Tightening
the nuts of these sockets is not that easy and takes a bit of fiddling
with a screw driver. Each nut has two notches on opposite sides and
a small screwdriver can be used to turn the nuts around until they are
tight enough. The FASTON tab of each banana socket fits inside the
corresponding slot of the PCB. X2 and X3 are the red sockets, X5 and X6
are the blue sockets and X7 is the yellow/green socket.
Now the 5 FASTON tabs of the banana sockets can be soldered.
When the 5 banana sockets are soldered the lid can be put on the
enclosure and to finish the assembly the 4 Philips screws can be fitted.
The LISN is now ready for use.
3/5
