Eleiko 3060281-03, Mounting Instruction

Page: 5 / 10

1. Mount the floor crossbar between the right
hand side with the left hand side. Use 1st and 3rd
hole from the back. Pretension the bolts before
the whole rack is raised up.
2. Mount the crossbar with ”Eleiko-brackets” in
the top between the two uprights with lasercutted
numbers. Pretension the bolts before the whole
rack is up.
3. Insert the weight suspension pins in the big
holes of the upright in the back. Make sure to use
a rubber hammer to knock the bolts in through
the upright in the back and through the weight
suspensions. (Don’t remove the small weld bump
on the weight suspension pin)
Tightening torque is 197 Nm for M16 bolts. Make
sure all bolts are tightened before putting on the
accesories.
4.
Hang the J-cups on at desired height.
1
2
3
3
3
3
3
3
4
4