CONGRATULATIONS ON YOUR PURCHASE
Thank you for purchasing this Eagle Puck Light Kit. Please read these instructions carefully
and leave with the user of the product for future reference. If the product is sold on then the
instruction/manual should pass on as well.
BEFORE USE
You must inspect the product and all accessories including any cables or leads for any signs
of damage. If the product is damaged, DO NOT use it, and contact your supplier immediately.
PRODUCT SAFETY
• Children shall not play with the unit.
• Cleaning and user maintenance shall not be made by children without supervision.
• Please ensure device is switched off when not in use.
• Do not use the device for other than its intended use.
• Please ensure the product is not stored in a hot or humid location.
• Do not use this product in bathrooms or other very hot humid locations.
• Periodically check this product and its power supply for damage. If any is detected do not
use and contact your supplier.
• Do not leave this product on unattended.
• The power supply MUST be kept in a well-ventilated area away from sources of heat and
moisture such as cookers and kettles
INCLUDED IN THE BOX
1 x 6 puck lights 12 x Wood screws 1 x Controller
6 x Sticky pads 1 x Remote Control
INFORMATION
• Plan your installation before fitting
• Maximum lead length from puck to puck is 0.5m
• While the product comes with both doubled sided sticky foam pads and wood screws in
most circumstances the pads on their own will usually be sufficent for permanent fixing.
before using the wood screws
the installer should take care to make sure they are suitable for the location.
• When using the sticky pads for installation ensure all surfaces are clean and clear of
grease and dust.
INSTALLATION
Fix each puck in place using either the sticky foam pads or wood screws. If using the screws
only use the two outer fixing points on the puck as per the image below. Access to these can
be gained by unscrewing the top of the puck and removing the plastic diffuser. This should be
replaced after installation. The pucks connect via a plastic 4 pin connector on the end of the
attached leads.
Each puck connects to each other by connecting the leads together on the pucks. Image
above - ensure when connecting, the arrows on each connection line up.
When all the pucks have been installed connect the power supply to the lead puck and switch
on.