ASA101A User Manual - work in progress
17 / 17
Earthing for function and safety
For functional and/or safety reasons you may wish to EARTH the casing of your Electron Plus instrument.
This is not necessary under most normal operating conditions.
In this case, we recommend loosening (and re-tightening) the M3 stainless steel chassis screw (2mm HEX
drive) and fitting an earthing wire using either ring terminal or spade terminal.
If in doubt please contact Electron Plus for further details.
Note
USB 0V, rear panel, front panel, casing and any external power supply
are all the same potential and connected via low impedances. Avoid
creating 'ground loops' with your setup.
