© 2018 Electromedical Technologies, Inc. Phoenix, AZ USA. Any use of editorial, pictorial or layout composition of this publication without express written consent from Electromedical Technologies,
Inc. is strictly prohibited. This publication was written, illustrated and prepared for print by Electromedical Technologies, Inc
7
Storage/Usage/Transportation:
Storage/Transportation temperature: -10° C ~ +65° C (avoid direct sun exposure)
Operating temperature: 0° C ~ +55° C (avoid direct sun exposure)
Maintenance & Cleaning Method:
Lead Wires and Carbon Rubber Electrodes:
Clean with a damp cloth and wipe dry with cloth or towel. Do
not use bleach or harsh cleaners.
Unit
: Use moist cloth and avoid any abrasive chemicals.
Radiofrequency interference with medical devices:
The past few years have seen increased reports that medical devices, such as pacemakers, apnea monitors,
electrically powered wheelchairs, etc., have failed to operate correctly because of interference from various
emitters of radiofrequency energy. This condition is called radiofrequency interference (RFI). The
consequences of these failures range from inconvenience to serious injuries and death. Reasons for this
problem are twofold: 1) increasing numbers of electronically controlled medical devices with inadequate
electronic protection against RFI, and 2) a significant increase in the number of RF sources in the environment.
Medical devices are widely used outside the hospital and may be attached to, or implanted in, patients.
Portable wireless communications equipment, including cellular phones, handheld transceivers, and vehicle-
mounted transceivers, comprise one of the largest sources of RFI. Some medical devices are especially
sensitive to the type of digital modulation that some of the wireless communications devices utilize.
NOTE:
The
WellnessPro 2010 Plus
is designed to fully comply with these requirements and is safe for usage in hospitals
among other medical devices.
NOTE:
No serviceable components inside.
Any attempt to open the device will result in all the unit functions being instantly disabled and the following
screen:
