6
TARGET TORQUE INDICATION
The TSD screwdriver will alert you to reaching 90% of the target value by
an audible beep and a green LED light, when you hit 100% the beep will
turn to a steady tone. When the torque applied is greater than the target a
red light will illuminate above the green.
MEMORY
The TSD can store up to 50 readings in memory for recall on the display.
To store a reading in memory set the screwdriver to
P
(peak) mode and
take a reading. When the reading is on the display press the
M
key to
store the reading and zero the screwdriver.
To recall stored readings press and hold the
U/S
key for 2 seconds, the
display will show
MODE
, then press
U/S
key one time, the display will
alternate between
n0XX
(XX = the reading number) and the stored read-
ing. Press the up / down arrows to toggle between readings. Press the
U/
S
key twice to return to measurement mode.
To clear the stored readings press and hold the
U/S
key for 2 seconds,
the display will show
MODE
, then press
U/S
key two times. CLr will be
shown on the display. Press the
C
key twice to confirm the deletion of the
readings.
WARNING
, this procedure will delete the entire contents of the
memory, it is not possible to delete individual readings.
CALIBRATION
We recommended annual calibration of the TSD Screwdriver to ensure it
is measuring according to factory specifications. For calibration service
please return to:
ELECTROMATIC Equipment Co., Inc
Attn Calibration Department
600 Oakland Ave
Cedarhurst, NY 11516
Please visit www.checkline.com/repair for complete instructions and ser-
vices rates.
3
SPECIFICATIONS
Accuracy*
Clockwise
: ±2%
Counterclockwise
: ±3%
The accuracy of displayed value is guaranteed
from 20% to 100% of maximum range ± least
significant digit.
Capacity
Resolution
Presets
9 Programmable setpoints with both audible
beep and Green/Red LED indicator
Memory
50 readings
Operating Modes
Peak and Track
Drive
1/4 Inch - 6.35 mm Hex
Operating Temp.
-10°C - 60°C
Storage Temp.
-20°C - 70°C
Dimensions
Length (without bit): 200mm / 8in
Diameter at largest point: 29.5mm / 1.16in
Weight
430g
Warranty
1 Year
Power Supply
1x AAA Battery (included)
Battery Life
12 Hours of continuous operation
Auto Off
Automatic power off after 5 minutes of non-use
TSD-50
50 cN-m
4.42 lb-in
5.1 Kg-m
TSD-400
400 cN-m
35.39 lb-in
40.82 kg-cm
TSD-50
0.1 cN-m
0.01 lb-in
0.01 Kg-m
TSD-400
0.1 cN-m
0.01 lb-in
0.01 Kg-m
