12
6. Place new belt around motor
shaft.
Left side view
7. Place belt around brush roll pulley.
8. Pull right side of brush roll to stretch belt. Secure
right end cap into base.
9. Align left end cap with square in base. Push end
cap into place; see left side view.
10. Rotate brush roll to seat belt.
11. Replace the hood. Make sure hood front is behind
furniture guard.
12. Tighten screws.
5
6
7
8
9
To Change Dust Cup Pleated Filter:
CAUTION:
Turn off the switch and unplug the
electrical cord before changing the
Pleated Filter. Never operate the
vacuum cleaner without the dust
cup or the pleated filter assembly.
Release dust cup by rotating dust cup latch to the
left pointing to the unlock symbol ( ). Pivot dust
cup out and away from cleaner and remove.
Remove cyclonic dust cup by pulling latch (1)
forward, pivoting cyclonic dust cup out and lifting
up. To replace cyclonic dust cup, put bottom of
cyclonic dust cup in place by aligning tabs in
slots and pivot top assembly back into place.
Push down on latch (1), making certain that
latch securely snaps and overlaps tabs at top
of dust cup.
To maintain good performance, check and
clean the Pleated Filter each time the dust cup
is emptied and clean if needed. The filter can
be cleaned by washing with mild detergent and
warm water. Be sure pleated filter is completely
dry before reinstalling.
Dust Cup
Latch
Dust Cup
1
2
