6
When finished cleaning, switch off the cleaner before rewinding the
electrical cord. Unplug the cleaner from the wall socket and press the
cord rewind pedal. Hold the plug with one hand and guide the electrical
cord with the other hand to prevent it from striking you or the cleaner.
SELECTING ACCESSORIES
Combination floor nozzle
The combination floor nozzle can be set for hard
floors or carpets. Press the foot operated toggle
lever on the floor nozzle to select the desired setting.
When the floor nozzle is set for hard floors, the bristles
will extend beyond the base of the floor nozzle. When
the floor nozzle is set for carpets, the bristles will be retracted.
Combination upholstery and brush nozzle
This nozzle can be used for upholstery or brushing.
To clean upholstery, open the two flaps on the nozzle
and attach it with the bristle side facing the extension
tube.
To use the brush side of the nozzle, close the two flaps and attach the
nozzle to the extension tube.
Combination crevice nozzle and dusting brush
This nozzle can be used as a crevice nozzle or as
a dusting brush. To select the desired setting rotate
the end of the nozzle to change from crevice nozzle
to dusting brush.
The crevice nozzle can be used for cleaning crevices, corners, between
cushions or difficult to reach places. The dusting brush can be used to
clean furniture, books, lamp shades and shelves.
EMPTYING THE DUST CONTAINER
Note:
The dust container should be emptied after each vacuum cleaning,
or as necessary, and when filter indicator lights up and stays on.
1. To remove the dust container, unlock it by pressing
the two buttons situated on either side of the handle
and pull it out.
2. Press the orange locking lever on the dust container
to open the lid. To prevent dust escaping from the
dust container, place the dust container inside a
plastic bag before opening the lid.
3. Clean the dust container, close the lid ensuring that
the orange locking lever clicks into position.
4. Replace the dust container by pushing it down lightly until the locking
catch clicks into position.
CLEANING OR REPLACING THE FILTERS
Caution: Before doing any type of cleaning or maintenance to the
cleaner, always ensure that the cleaner is unplugged from the wall
socket.
Damaged filters must be replaced immediately. Do not operate the
cleaner with damaged or clogged filters.
Do not clean the filters in a washing machine and do not use a hair
dryer to dry the filters.
Do not use cleaning agents or hard bristled brushes as they may damage
the delicate filter surfaces.
Dust container filters
Note:
There are two filters in the dust container. A HEPA filter and a fine
mesh cage filter. These two filters must be cleaned regularly. Check and
if necessary clean or replace these filters each time that the dust container
is emptied or when the filter indicator lights up and stays on.
7
Push
