16
Troubleshooting
Before You Call for Service
If the unit appears to be malfunctioning, read
through this manual first. If the problem persists,
check the Troubleshooting Guide below. Locate
the problem in the guide and refer to the cause
and its remedy before calling for service. The
problem may be something very simple that can
be solved without a service call. Some remedies
listed in the Troubleshooting Guide are very
complex. Consulting or contracting a qualified
service technician may be necessary.
If Service is Required
Contact the dealer where you purchased the unit
if service is required. State the model and serial
number and explain the problem. The model and
serial number plate is located on the ceiling of your
unit.
If you do not know the name of the selling dealer or
a local service company, you can check online at
www.electroluxusa.com
or call
1-877-435-3287
.
DANGER
ELECTROCUTION HAZARD
NEVER attempt to repair or perform maintenance on the unit until the main electrical power has
been disconnected.
Problem
Possible Cause
Remedy
Unit not cold enough.
Adjust temperatures (see “Adjusting
the Temperature” in the “
Start-Up
and Temperature Control” section).
• Control set too warm.
• Light staying on.
• Airflow to front grille blocked.
• Door gasket not sealing properly.
• Adjust temperature colder. Allow
24 hours for temperature to
stabilize.
• Turn off manual light control. See
“Operation” Section.
• Airflow must not be obstructed
to front grille. See “Installation”
Section.
• Adjust door gasket.
Unit too cold.
Adjust temperatures (see “Adjusting
the Temperature” in the “
Start-Up
and Temperature Control” section).
• Control set too cold.
• Adjust temperature warmer.
Allow 24 hours for temperature to
stabilize.
No interior light.
• Failed LED assembly.
• Contact a qualified Electrolux
Service Technician.
Light will not go out when door is
closed.
• Manual light control is ON.
• Door switch not making contact.
• Turn off manual light control. See
“Operation” Section.
• Check for proper door alignment.
