Problem
Possible cause
Possible solution
You did not remove the stub-
born stains before you wash
the laundry.
Use special products to remove the
stubborn stains.
You set a not correct tempera-
ture.
Make sure that you set the correct tem-
perature.
Too much laundry load.
Decrease the laundry load.
The internal lamp is
off.
The lamp is burned.
To replace the lamp, contact the service
centre.
After a steam pro-
gramme, garments
are partially wet.
The appliance is not accurately
levelled.
Check the levelling and adjust the appli-
ance by raising or lowering the feet.
After a steam pro-
gramme, garments
are not sufficiently
smooth.
A wrong STEAM programme
has been selected (e.g. Syn-
thetic instead of Cotton).
Note the composition of the fabric.
Excessive laundry load.
Reduce the laundry load
The drum is empty
and the display
shows there is some
weight in .
It is necessary to set a tare.
Press button
1
to deactivate the appli-
ance and to activate it again.
The drum is full but
the display shows
0.0 kg.
You loaded the laundry before
to activate the appliance.
Press button
1
to deactivate the appli-
ance . Empty the drum and obey to the
necessary steps. (Refer to 'Loading the
laundy')
After the check, activate the appliance. The
programme continues from the point of in-
terruption.
If the problem occurs again, contact the
service centre.
If the display shows other alarm message,
contact the service centre.
INSTALLATION
FIXING PLATE KIT (4055171146)
Use this special accessory, when you install
the appliance on a plinth.
It prevents the movements of the appliance
when it operates.
Read carefully the instructions supplied with
this accessory.
You can buy it in all approved Service.
UNPACKING
1. Use the gloves. Remove the external
film. If necessary, use a cutter.
2. Remove the cardboard top.
electrolux
25
