Electrolux WA GL6 E 101, User Manual

Page: 26 / 32

The machine must not be installed in rooms
where the temperature can drop below
0°C.
The water inlet hose and the drain hose
must not be kinked.
Please ensure that when the appliance is
installed, it is easily accessible for the engi-
neer in the event of a breakdown.
Carefully level by screwing the adjustable
feet in or out. Never place cardboard, wood
or similar materials under the machine to
compensate for any unevenness in the
floor.
Water inlet
An inlet hose is supplied and can be found
inside the machine drum.
Caution! This appliance must be
connected to a cold water supply.
Do not use the hose from your pre-
vious machine to connect to the
water supply.
1. Open the porthole and extract the inlet
hose.
2. Connect the hose with the angled con-
nection to the machine.
Caution! Do not place the inlet
hose downwards. Angle the hose
to the left or right depending on the
position of your water tap.
3. Set the hose correctly by loosening the
ring nut. After positioning the inlet hose,
be sure to tighten the ring nut again to
prevent leaks.
4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to pur-
chase a new, longer hose specially de-
signed for this type of use.
Installation should comply with local
water authority and building regulations
requirements. Check the minimum wa-
ter pressure required for safe operation
of the appliance in the chapter "Techni-
cal Data".
26 electrolux