2 1
The symbol
L
shown on the product means that it must
not
be
considered as domestic refuse, but rather must be disposed of
properly, in order to prevent any negative consequence for
individuals or the environment.
For further information concerning the recycling of this product,
contact the product’s local retailer agent, after sales technical
service or the local authority for waste disposal.
B.1.3 POSITIONING
B.1.3.1 General instructions
Install the equipment, taking all the safety precautions re-
quired for this type of operation, also respecting the relative
fire-prevention instructions.
Place the appliance in a well-ventilated place, away from heat
sources such as radiators or air-conditioning systems, in order to
allow correct cooling of the refrigerating unit components. Insuf-
ficient ventilation will in fact damage the appliance and prevent it
from working properly. Also, if the temperature is very high, the
compressor will activate more frequently and for longer periods
of time, resulting in higher consumption of electrical energy.
Keep the ventilation openings free of any sort of obstruction.
Never cover the condenser, even temporarily, as this may com-
promise its proper operation and therefore that of the appliance.
If the appliance is installed in rooms where there are corrosive
substances (chlorine, etc.), it is advisable to go over all the
stainless steel surfaces with a cloth soaked in paraffin oil to create
a protective film.
The equipment’s performance is guaranteed at an ambient
temperature of +38°C. In any case, the max. ambient tempera-
ture at which the equipment can operate is +38°C.
Adjust height and levelling by means of the levelling feet,
while at the same time checking the doors for proper closure.
Align the door with the side, adjusting the hinge on the bottom of
the appliance: remove screw
"a"
from its seat
b
a
and screw it in slot
"b"
provided on the edge as shown in the figure
b
b
Now, with the hinge loosened, the door can be aligned.
After completing the operation, tighten the screw.
Make sure the floor on which the appliance stands is perfectly
level, in order to ensure its optimal operation.
CAUTION:
the appliance must be level, otherwise its operation could be
compromised.
CAUTION:
wait at least 2 hours before starting the appliance to allow the oil
to flow back into the compressor.
B.1.3.2 Instructions for "V170" undercounters
For positioning "V170" undercounters under a worktop, proceed
as follows:
• undo the screws fixing the top to the appliance, located at the
back;
• slide the top outwards a little to release it from the stops and
remove it from its seat;
• undo the screws fixing the rear feet to the appliance;
• remove the 3 mm spacer from the feet and reposition them in
their seats;
• lastly, fit the front feet and adjust them until the appliance is at
the required height.
- ADJUSTMENT OF TEMPERATURE IN REFRIGERATED
APPLIANCES:
Turn the knob of the thermostat to “6”, “1” or any position in
between.
0
6
The thermostat knob is located at the upper right and is used to
set the temperature at which you wish the appliance to work. The
most suitable operating temperature needs to be selected in light
of the following factors:
• the ambient temperature in which the appliance operates;
• how often the door is opened;
• the amount of food stored;
• the position of the appliance with respect to the setting where
it is installed.
