Electrolux TWSL6S7000, Instructions For Use Manual

Page: 65 / 68

Consumption values
The consumption values have been established under standard conditions. They may deviate when
the machine is operated in domestic circumstances.
Programme
Energy consumption in kWh / average dry-
ing time in min.
COTTON CUPBOARD DRY
3)
1.9/ 135 (7 kg load pre-drained at 1000 rpm)
1.7 (7 kg load pre-drained at 1200 rpm)
1.65 (7 kg load pre-drained at 1400 rpm)
1.42 (7 kg load pre-drained at 1800 rpm)
COTTON IRON DRY
3)
1.4/ 106 (7 kg load pre-drained at 1000 rpm)
SYNTHETICS CUPBOARD DRY
3)
0.59/ 48 (3 kg load pre-drained at 1200 rpm)
1) different loading volume data may be needed in some countries as a result of different measuring methods
2) in accordance to EN 61121
3) hints for test institutes: cycle has to be checked in accordance to EN 61121
MACHINE SETTINGS
Setting Implementation
Buzzer permanent
on/off
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness (Trockengrad) and Spin Speed (U/
Min) buttons and hold down for approx. 5 seconds.
3. The buzzer is by default always off. You can use the buzzer option to
activate or deactivate sound but the machine does not memorise your
selection.
Water hardness
1)
1. Turn the programme selector to any programme.
2. Press simultaneously the Dryness (Trockengrad) and Time (Zeitwahl) but-
tons and hold down for approx. 5 seconds. The current setting is on
the display:
–
low conductivity <300 μ S/cm
–
medium conductivity 300-600 μ S/cm
–
high conductivity >600 μ S/cm
3. Press the Start/Pause button sequentially until you set desired level.
4. To memorise setting press simultaneously the Dryness (Trockengrad)
and Time (Zeitwahl) buttons or turn knob to Off (Aus) position
Emptying water res-
ervoir
- warning
off
2)
1. Turn the programme selector to any programme.
2. Press simultaneously the Spin Speed (U/Min) and Time (Zeitwahl) but-
tons and hold down for approx. 5 seconds.
The current setting is on the display:
– warning icon and
- warning message is off
– warning icon and
- warning message is switched on
1) Water contains, a variable quantity of limestone and mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values. Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly influence the residual humidity of the laundry at the end of
the cycle. Your dryer allows you to regulate the sensitivity of the drying sensor based on conductivity values of the
water.
2) By default the warning LED is always on at the end of the drying cycle or during the cycle if the water reservoir is
full. When using an external drain for the condensed water warning can be offi
65