1. Go to the App Store on your smart
device.
2. Download and install App My AEG .
3. Make sure you started a Wi-fi
connection in the dryer. If not go to
the section below.
4. Start the application. Select the
country and language and login with
Your email and password. If you do
not have an account, create a new
one following the instructions in My
AEG.
5. Follow the instructions on the App for
the appliance registration and
configuration.
A message appears on the appliance
display to confirm that the configuration
was successful.
5.2 Over-the-air update
The App may propose an update for your
appliance.
The update is accepted via App only.
If a programme is running, the App
notifies that the update will start at the
end of the programme.
During the update, the appliance shows
in the display.
Do not switch off or unplug the appliance
during update.
The appliance will usable again at the
end of the update, without any
notification about successful update.
If an error occurs, the appliance shows
in the display: just press any
buttons or turn the knob to return to
normal use.
5.3 Wireless connection
configuration
Before you begin configuration download
and install My AEG application on your
smart device.
1. Push the On/Off (Ein/Aus) button
to switch on the appliance.
2. Wait approximately 8 seconds.
3. Touch and hold down the Refresh
(Auffrischen) and Delay Start
(Zeitvorwahl) buttons at the same
time.
The symbols:
and
appear on the
display. After few seconds remains only
flashing symbol:
. Wireless module is
activating around 1 minute. When ready
the symbol:
(Access Point) appears
on the display. Access Point is open
around 3 minutes.
4. Configure My AEG application on
your smart device.
If the configuration is successful the
symbol:
(Access Point) disappears
and the symbol:
stops flashing.
Each time you switch the
appliance on, the appliance
attempt to connect to the
network automatically. When
the connection is established
the symbol:
stops
flashing.
To switch off the wireless connection ,
touch and hold down Refresh
(Auffrischen) and Delay Start
(Zeitvorwahl) buttons at the same time
for 3 seconds. The symbol:
appears on the display.
Appliance stores last
connection configuration. To
use wireless features of the
appliance the wireless
connection must be in
mode.
To remove the wireless credentials,
touch and hold down Refresh
(Auffrischen) and Delay Start
(Zeitvorwahl) buttons at the same time
for 10 seconds. The symbol:
appears on the display.
www.electrolux.com
12