• before you push the Start/Pause button -
the appliance cannot start
• after you push the Start/Pause button -
all the push buttons and the programme
dial are deactivated
AT THE END OF PROGRAMME
When the drying cycle is completed, the
symbol flashes on the display. If the Buzzer
(Signal) function is on, an acoustic signal
sounds intermittently for one minute.
To remove the laundry:
1. Push the On/Off (Ein/Aus) button for 2
seconds to deactivate the appliance.
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Important!
After each drying cycle:
• clean the filter
• drain the water container
(See chapter
CARE AND CLEANING
.)
HINTS AND TIPS
ECOLOGICAL HINTS
• Do not use fabric softener to wash and
then dry. In the tumble dryer laundry be-
comes soft automatically.
• Use the condensate as distilled water,
e.g. for steam ironing. If it is necessary
clean the condensate before (e.g. with a
coffee filter) to remove possible small
pieces of fluff.
• Always keep the airflow slots on the bot-
tom of the appliance clear.
• Use the load volumes which are specified
in the programmes chapter.
• Make sure that is good airflow in the ap-
pliance installation position.
• Clean the primary filter after each drying
cycle.
• Clean the heat exchanger filters when the
applicable indicator comes into the view
on the control panel.
• Spin good the laundry before drying.
WATER HARDNESS AND
CONDUCTIVITY
Water hardness can be different for differ-
ent locations. Water hardness has an effect
on the water conductivity and the operation
of the conductivity sensor in the appliance.
If you know the value of the water conduc-
tivity you can adjust the sensor to dry with
the better results.
To change the sensor conductivity:
1. Turn the programme dial to available
programme.
2. Push at the same time the Anticrease
(Knitterschutz) and Time Drying (Zeit-
wahl) buttons and hold down until one
of the these symbols go into view on
the display:
–
low conductivity <300
μ
S/
cm
–
moderate conductivity
300-600
μ
S/cm
–
high conductivity >600
μ
S/
cm
3. Push the Start Pause button again and
again until you set necessary level.
4. To memorise setting push at the same
time the Anticrease (Knitterschutz) and
Time Drying (Zeitwahl) buttons.
WATER CONTAINER FULL —
INDICATION
By default the indication LED is always on.
It comes into the view at the end of the cy-
cle or when the water container is full.
When you use an external equipment to
drain the container, the LED can be off.
To activate or deactivate the indication:
1. Turn the programme dial to available
programme.
2. Push at the same time the Anticrease
(Knitterschutz) and Delay Start (Zeitvor-
wahl) buttons and hold down until you
see the correct setting:
– the LED is off and the symbol
goes into the view - The LED
is permanently off
– the LED is on and the symbol
goes into the view - The LED
is activated
68
electrolux
