electrolux
27
GB
When the refrigerator is not in use
In case the appliance will not be used for
a long time follow these steps:
Break the circuit of the appliance.
Remove foods from the refrigerator.
Defrost and clean it as written before.
Leave the door open to avoid a build up
of air inside.
Trouble shooting
During operation of the appliance some
smaller but annoying trouble can often
occur, which does not require calling a
technician out. In the following chart
information is given about them to avoid
unnecessary charges on service.
Problem
The appliance
does not cool
sufficiently
The appliance
cools too hard
The appliance
does not cool at
all
The appliance is
noisy
Possible cause
Thermostatic control is set too low.
Before freezing the appliance was
not pre-cooled sufficiently.
Large-sized food was put in.
Too many foods to be frozen were
put in.
Warm foods were put in.
Door is not shut properly.
The thermostatic control is set too
high.
Plug is not connected to the mains
socket properly.
There is no voltage in the mains
socket.
Thermostatic control is in „STOP”
position.
The appliance is not supported
properly.
Solution
Set higher position.
Pre-cool the appliance for
enough time.
Cut up food.
Put fewer foods to be cooled.
Put foods max. at room
temperature.
Check if the door is shut.
Set lower position.
Check if the connection is
proper.
Check if there is voltage.
Check setting of thermostatic
control.
Check if the appliance stands
stable.
Inasmuch as the advice does not lead to result, call the nearest brand-mark service.
We draw your attention that operation of
appliance goes with certain sounds
(compressor- and circulating sound). This
is not trouble, but means normal
operation.
We draw it to your attention again
that the appliance operates
discontinuously, so the stopping of
compressor does not mean being no-
current. That is why you must not touch
the electrical parts of the appliance
before breaking the circuit.
