Electrolux TC15013, User Manual, Page: 17 / 24

2
1
• Remove the door by pulling it down-
wards while keeping it slightly opened.
• Unscrew the upper door hinge, and
screw it in on the opposite side.
• Put the door back in its place.
• Relocate the door holder pin in the door
hinge as per the figure.
• Place the door holder pin in the door at
the bottom on the left side, and fix the
door hinge with the screw.
1
2
• Screw the right foot.
• Raise the appliance in the upright posi-
tion.
• Remove and install the handle (if fore-
seen) on the opposite side.
• Reposition, level the appliance, wait for
at least four hours and then connect it to
the power socket.
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in
Winter), the gasket may not fit perfectly to
the cabinet. In that case, wait for the natu-
ral fitting of the gasket. In case you do not want to carry out the
above mentioned operations, contact the
nearest After Sales Service Force. The After
Sales Service specialist will carry out the
reversibility of the doors at your cost.
PLUG SOCKET
CAUTION!
Make sure that the mains cable
can move freely.
The plug socket necessary for connection
of your appliance to the electricity supply
should be positioned so that it is possible
to pull out the appliance plug.
If your appliance is installed under a contin-
uous worktop, the plug socket should be
provided as shown.
ELECTRICAL CONNECTION
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power sup-
ply.
The appliance must be earthed. The power
supply cable plug is provided with a con-
ENGLISH 17