Electrolux T41200, Programming Manual

Page: 11 / 16

11
Programming
Adjusting operating temperatures
1.­ Press­Enter.
The display shows 0 01, indicating Group 0, parameter
location­01­=­High­temperature.
2.­ Press­Enter­again­to­enter­this­parameter­location.­The­
display­shows­_­70­(°C).
Note: The flashing bar at the bottom of the left digit
indicates that this is a two-digit parameter.
3.­ Press­Enter­key­to­edit­this­parameter­value.­The­“70”­will­
begin­to­flash.
4.­ Press­Down­to­lower­the­value­or­Up­to­increase­it.
Note: The Up and Down may be pressed and held to
make more rapid value changes.
5.­ Press­Enter­key­to­save­the­new­value
­ In­this­example,­the­High­temperature­has­been­changed­
to­65°C.­The­value­is­saved­when­the­parameter­stops­
flashing and the flashing _ reappears­in­the­left­digit.
6.­ Press­Return­to­leave­this­parameter.
7.­ To­adjust­the­Medium­or­Low­temperature,­press­Up­to­go­
to­the­proper­parameter­location.
Location 0 02 is the Medium drying temperature (factory
set­to­60°C).
Location 0 03 is the Low drying temperature (factory set
to­50°C).­
Press­Down­to­go­back­if­you­pass­the­desired­location.­
Press Enter to enter and edit the Medium or Low tempe-
rature,­as­described­in­steps­3-5.
8.­ Press­service­button­A­when­the­programming­is­done.
9.­ Assemble­and­test­the­dryer.
487 22 93 40.00
SELECTA CONTROL
487 09 10 00.00
487 22 93 40.00
SELECTA CONTROL
487 09 10 00.00
487 22 93 40.00
SELECTA CONTROL
487 09 10 00.00
487 22 93 40.00
SELECTA CONTROL
487 09 10 00.00
487 22 93 40.00
SELECTA CONTROL
487 09 10 00.00
1.
487 22 93 40.00
SELECTA CONTROL
487 09 10 00.00
2.
3.
5.
4.
6.
487 22 93 40.00
SELECTA CONTROL
7.