Problem
Possible cause
Solution
The compressor does not
start immediately after
pressing the "Extra
Freeze", or after changing
the temperature.
The compressor starts af‐
ter a period of time.
This is normal, no error
has occurred.
Door is misaligned or inter‐
feres with ventilation grill.
The appliance is not level‐
led.
Refer to installation instruc‐
tions.
Door does not open easily. You attempted to re-open
the door immediately after
closing.
Wait a few seconds be‐
tween closing and re-open‐
ing of the door.
The lamp does not work.
The lamp is in stand-by
mode.
Close and open the door.
The lamp is defective.
Contact the nearest Au‐
thorized Service Centre.
There is too much frost
and ice.
The door is not closed cor‐
rectly.
Refer to "Closing the door"
section.
The gasket is deformed or
dirty.
Refer to "Closing the door"
section.
Food products are not
wrapped properly.
Wrap the food products
better.
Temperature is set incor‐
rectly.
Refer to "Operation" chap‐
ter.
Appliance is fully loaded
and is set to the lowest
temperature.
Set a higher temperature.
Refer to "Operation" chap‐
ter.
Temperature set in the ap‐
pliance is too low and the
ambient temperature is too
high.
Set a higher temperature.
Refer to "Operation" chap‐
ter.
Water flows on the floor.
The melting water outlet is
not connected to the evap‐
orative tray above the com‐
pressor.
Attach the melting water
outlet to the evaporative
tray.
Temperature cannot be
set.
The Extra Freeze function
is switched on.
Switch off the Extra Freeze
function manually, or wait
until the function deacti‐
vates automatically to set
the temperature. Refer to
"Extra Freeze function"
section.
The temperature in the ap‐
pliance is too low/too high.
The temperature is not set
correctly.
Set a higher/lower temper‐
ature.
www.electrolux.com
86
Summary of Contents for SG235NFICN
Page 91: ......