13
F3
Positioning
The machine must be taken to the place of installation
and the packing base removed only when being
installed.
Arranging the machine:
•
Wear protective gloves and unpack the machine
(Figure 8).
Figure 8 Unpacking
•
Lift the equipment with a lift truck, remove the base
and position it the place of use (Figure 9).
Figure 9 Machine positioning
•
Carefully remove the protective film from the outer
panels without tearing it, to avoid leaving traces of
glue (Figure 10).
•
Figure 10 Removing the film
•
Adjust the equipment by turning the special adjust-
able feet and making sure it is perfectly level, both
lengthwise and crosswise (Figure 11).
Figure 11 Feet adjustment
F4
Disposal of packaging
All the packing materials are environmentally friendly.
They can be safely kept, recycled or burned in an
appropriate waste incineration plant. Recyclable plas-
tic components are marked as follows:
Parts in wood and cardboard can be disposed of,
respecting the current regulations in the country where
the machine is used.
F5
Plumbing connections
ATTENTION
Machines marked Watermark must be installed in
conformity with AS/NZS 3500.1, and the non-return
device supplied with the machine must also be
installed (B - Figure 12).
The drain must comply with 3500.2.
The machine water filling and drain pipes must be
installed according to the plumbing circuit and installa-
tion diagrams given below.
•
Connect the equipment water pipe “WI” (see par. F5.2
“Installation diagram”) to the water supply, interposing
a tap, the filter (if provided) and a pressure gauge
(Figure 12).
Figure 12 Supply pipe connection
polyethylene:
outer wrapping, instruc-
tion booklet bag.
polypropylene:
roof packing panels,
straps.
polystyrene
foam:
corner protection.
4x
PE
PP
PS
!
B
