Altering an option or a running programme
It is possible to change any option before the programme carries it out. Before you make
any change, you must pause the washing machine by pressing the button
8
.
Changing a running programme is possible
only by resetting it
. Turn the programme
selector dial to
and then to the new programme position. Start the new programme by
pressing the
8
button again. The washing water in the tub will not emptied out.
Interrupting a programme
Press the button
8
to interrupt a programme which is running, the corresponding light
starts blinking. Press the button again to restart the programme.
Cancelling a programme
Turn the selector dial to
to cancel a programme which is running. Now you can select
a new programme.
Opening the door after the programme has started
First set the machine to pause by pressing the button
8
. If the pilot light
10.2
goes off,
after some minutes the door can be opened.
If the door remains locked - the pilot light
10.2
is on, this means that the machine is already
heating, that the water level is above the bottom edge of the door. In this case the door
can not be opened. If you cannot open the door but you need to open it you have to switch
the machine off by turning the selector dial to . After some minutes the door can be
opened
(pay attention to the water level and temperature !)
.
After closing the door, it is necessary to select the programme and options again and to
press button
8
.
At the end of the programme
The machine stops automatically, the pilot light of button
8
, the pilot lights
10.1
and
10.2
go off and a blinking will appear on the display.
If a programme or an option that ends with water still in the tub has been selected, the
pilot light
10.2
illuminates, a blinking will appear on the display, the pilot light of button
8
goes off and the door remains locked to indicate that the water must be emptied out
before opening the door.
Follow the below instructions to empty out the water:
• Turn the programme selector dial to
• Select the DRAIN or SPIN programme
• Reduce the spin speed if needed, by means of the relevant button
• Press button
8
• When the programme has finished the display shows a blinking . The pilot light
10.2
goes off and the door can be opened.
Turn the programme selector dial to to switch the machine off. Remove the laundry
from the drum and carefully check that the drum is empty. If you do not intend to carry
out another wash, close the water tap. Leave the door open to prevent the formation of
mildew and unpleasant smells.
Daily use
13
Summary of Contents for LAVAMAT 60840 L
Page 1: ...LAVAMAT 60840 L 62840 L User manual Washing Machine ...
Page 34: ...34 ...
Page 35: ...35 ...
