What to do if…
24
What to do if…
Remedying small malfunctions
Before you call the Customer Care Department, please check whether
–
you cannot remedy the fault yourself with the help of the following fault ta
ble
or
–
whether it is caused by faulty, electrical connections and/or faulty water con
nections.
In these cases the engineer must make you liable for the costs of the Customer
Service intervention even during the warranty period.
If while the appliance is operating indicators on the control panel flash or are lit
up as described in the following table, please consult this to find out how to
remedy the fault.
After remedying the fault that is flashing in the
first or second rhythm
in the
programme progress display, press the startbutton. The cycle will continue.
In the case of other fault messages:
–
Cancel the dishwashing cycle.
–
Switch the appliance off and on again.
–
Select dishwashing cycle.
If the fault is displayed again, please contact the Customer Care Department
and inform them of the fault message.
Malfunction
Possible cause
Remedy
The indicator for the end of the
dishwashing cycle is flashing in
rhythm 1
short light signal with
approx. 3 second pause inbe
tween:
(Problems with water inlet)
The tap is blocked or furred
with limescale.
Clean tap.
The tap is turned off.
Turn on the tap.
The filter (where present) in the
threaded hose fitting on the tap
is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the wash
ing compartment are blocked.
Cancel the dishwashing cy
cle (see section: Starting a
dishwashing cycle);
clean filters (see section:
Cleaning the filters).
Water inlet hose
has not been correctly posi
tioned.
Check hose installation.
