Install the exhaust hose (see page 7-8, turn the drainage
nozzle to the CLOSE position, and check the drainage
nozzle is covered with the stopcock.
1. Press the MODE button to select COOL mode.
. Press the ON/OFF button to start operation.
• The red OPERATION lamp on the unit will illuminate.
Make sure they are securely attached.
3. Press the TEMPERATURE button to set the desired
temperature.
• The temperature can be set within the range of
18°C to 3°C.
4. Press the FAN button to set the desired fan speed.
To turn off
Press the ON/OFF button again.
• The red OPERATION lamp on the unit will turn off.
NOTES:
• To minimise noise it is recommended that during cooling
mode the drainage nozzle should remain in the CLOSE
position.
• To prevent water saturation ensure that stopcocks are
always fitted when not using separate drainage.
Cool mode
In this mode, the air conditioner dehumidifies the room
1. Remove the exhaust hose (see page 7-8).
. Turn the drainage nozzle to the OPEN position.
3. Pull the stopcock (upper) out from the drainage nozzle.
• When the stopcock (upper) is removed, a small amount
of water may be discharged from the drainage nozzle.
• Always perform this procedure with the unit turned
off. Drain water will squirt out if attempted during
operation.
4. Insert the hose clamp into a standard commercially-
available hose (1.7mm inner diameter, 16.7mm outer
diameter).
5. Attach the hose to the drainage nozzle, and secure it
with the hose clamp.
• Depending on room condition, approximately 8
litres of water per day (4 hours) will be dehumidified.
Prepare some kind of bucket of appropriate size to
collect drain water, or take some appropriate measure
to drain the water outside of the room, so that drain
water will not overflow or soak your room.
• Set the hose sloping downwards for easier drainage.
Moreover, do not bend the hose at any point, nor allow
the end to be submerged in water.
Drainage nozzle
Stopcock (Upper)
“CLOSE position”
1
4
2
3
COOL
AUTO QUIET
LOW
HIGH
DEHUM
FAN
VENT
Drainage nozzle
Stopcock (Upper)
“CLOSE position”
1
4
2
3
COOL
AUTO QUIET
LOW
HIGH
DEHUM
FAN
VENT
Drainage nozzle
Stopcock (Upper)
“CLOSE position”
1
4
2
3
COOL
AUTO QUIET
LOW
HIGH
DEHUM
FAN
VENT
COOL
DEHUM
FAN
VENT
COOL
DEHUM
FAN
VENT
COOL DEHUM
FAN
VENT
COOL DEHUM
FAN
VENT
Dehumidification mode
Drainage nozzle
Stopcock (Upper)
Hose clamp
Drain hose
COOL
“OPEN position”
DEHUM
FAN
VENT
7
6
Drainage nozzle
Stopcock (Upper)
Hose clamp
Drain hose
COOL
“OPEN position”
DEHUM
FAN
VENT
7
6
Drainage nozzle
Stopcock (Upper)
Hose clamp
Drain hose
COOL
“OPEN position”
DEHUM
FAN
VENT
7
6
electrolux EXP09CS1WI
installation of window kit 13
