Electrolux EWW1697MDW, User Manual

Page: 27 / 32

Problem Possible solution
The laundry is full of
different colours fluff. Set a drying cycle to remove some fluff.
Clean the laundry with a fluff remover.
There is a big quantity
of fluff in the drum. Repeat this procedure again and again:
• Clean the empty drum, the gasket and the door with a
wet cloth.
• Set a rinse cycle.
• Put a wool or piled fabric cloth in the drum.
• Set a drying cycle of 10 minutes.
• Remove the old wool cloth.
After the check, activate the appliance.
The programme continues from the point
of interruption.
If the problem occurs again, contact the
Service. If the display shows other alarm codes.
Deactivate and activate the appliance. If
the problem continues, contact the Serv-
ice.
15. TECHNICAL INFORMATION
Dimensions Width / Height / Depth 600 / 850 / 605 mm
Total depth 640 mm
Electrical connection: Voltage
Overall power
Fuse
Frequency 230-240 V
2200 W
13 A
50 Hz
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture IPX4
Water supply pressure
1) Minimum 0,5 bar (0,05 MPa)
Maximum 8 bar (0,8 MPa)
Water supply
2) Cold water
Maximum load Cotton 9 kg
Spin speed Maximum 1600 rpm
1)
The appliance works correctly if the water pressure is not less than 0.05 MPa (0.5 bar).
If you can not connect the water inlet hose to the cold water tap of the primary hydraulic
system, connect it to your domestic cold water storage system.
Make sure not to have more than a distance of 5.02 m (16.5 ft) between the appliance inlet
hose and the bottom of the water storage tank.
2)
Connect the water inlet hose to a water tap with a 3/4'' thread.
ENGLISH 27