Electrolux EWW12832, User Manual, Page: 11 / 44

ENGLISH 11
3.13 Vapour Option 3.10 Prewash Touchpad
* Vapour option cannot be
selected, if drying option
has been combined with
the program.
3.12 Start/Pause Touchpad
To start the selected program, press
the ‘Start/Pause’.
To interrupt a program which is
running, press the ‘Start/Pause’ to
pause the machine.
To restart the program from the point
at which it was interrupted, press the
‘Start/Pause’ again.
If you have chosen a delayed start,
after pressing ‘Start/Pause’ the
machine will begin the countdown.
Select this option if you wish your
laundry to be pre-washed before the
main wash. Use this option for heavy
soil.
The indicator of this option comes on.
When you set this function, put the
detergent into the “ ”
compartment. (Refer page 18-19)
This function increases the program
duration.
The indicator of this option comes on.
Vapour may not necessarily be
visible inside the drum during a
vapour wash cycle. Vapour is
created below the drum and
allowed to naturally rise into the
clothes.
NOTE:
At the end of the Vapour cycle the
clothes will be warmer, softer and
detached from the drum.
If Vapour option is selected,
rinse temperatures will be
elevated.
During a vapour cycle you may
notice vapour exiting from the
drain hose of the washer-dryer,
this is normal and there is no
cause for alarm.
Vapour may not be present during
the entire vapour wash cycle.
Vapour function is more effective
with half load.
3.11 Rinse Plus Touchpad
This option is recommended for
people who are allergic to detergents,
and in areas where the water is very
soft.
Press it to add rinsing phases to a
program.
The indicator of this option comes on.
Select this option * to add approxi-
mately 15-40 minutes of tumbling in
vapour during the wash cycle.
Vapour helps open fabric fibers up
to allow laundry additives to release
tough stains.
To activate, press ‘Prewash’ and
‘Rinse +’ touchpads at the same
time until the display shows the
symbol ‘ ’.
Setting Vapour option:
To deactivate, press ‘Prewash’
and ‘Rinse +’ touchpads at the
same time until the symbol ‘ ’
goes off.