background image

Daily use

Loading washing

• Open the lid of the

appliance.

• Open the drum by

depressing the
locking button A:
The two shutters
unlock automati-
cally.

• Load the washing,

close the drum and
the lid of your
washing machine.

Warning!

  Before closing the lid of your

appliance, ensure that the drum is properly

closed :
• When the two shutters are closed,
• locking button A released.

Proportioning of detergents

Pour the amount of washing powder into the
washing 

 and prewash 

 compartments if you

have selected the “prewash” option. Pour fabric
softener into the compartment   if necessary.

Selection of desired programme

Turn the programme selector to the required pro-
gramme. The “Start/Pause” pushbutton flashes
green.
If you turn the programme selector to another pro-
gramme while a cycle is in progress, the appliance
will ignore the new selected programme. The
“Start/Pause” pushbutton flashes red for a few
seconds.

Selecting the temperature

Press the “Temperature”   pushbutton repeatedly
to increase or decrease the temperature (see “Pro-
grammes table”). The 

 symbol means a cold

wash.

Selecting the spin speed

Turn the spin speed selector on the desired posi-
tion.
The maximum spin speeds are :
for Cottons, Synthetics, Easy iron, Wool, Hand-
wash : 900 rpm, for Delicates, Silk, Mini pro-
gramme : 700 rpm.
At the end of the programme, if you have selected
“Rinse hold” 

 or “Night silence plus” 

 , you

then need to select a “Spin” or “Drain” programme
to finish the cycle and empty the water.

Selecting options

You must select the different options after select-
ing the programme and before pressing the “Start/

A

Pause” pushbutton (see “Programmes table”).
Press the desired button(s) : the corresponding
lights come on. If pressed again, the lights go out.
If one of the options is not compatible with the se-
lected programme, the “Start/Pause” pushbutton
flashes red.

“Prewash” option

The appliance runs a prewash at 30°C max.

“Eco” option

This option allows you to choose a lower temper-
ature programme which is as effective as a higher
temperature wash programme.

“Super quick” option

The washing time will be reduced depending on
the programme selected.

“Rinse plus” option 

The washing machine will add one or more rinses
during the cycle. This option is recommended for
people with sensitive skin and in soft water areas.
Temporary : Press the “Rinse plus” 

 pushbut-

ton. The option is only active for the selected pro-
gramme.
Permanent : Hold down the “Temperature”   and
“Options” pushbuttons for a few seconds. The op-
tion is permanently activated, even if the appliance
is switched off. To deactivate it, repeat the proc-
ess.

“Delay start”

This option allows you to delay the start of a wash
programme by 3, 6 or 9 hours by pressing the
“Delay start” pushbutton.
You can change or cancel the delayed start time
at any time before you press the “Start/Pause”
pushbutton by pressing the “Delay start” pushbut-
ton again (when all indicators are off, the wash
programme will start immediately).
If you have already pressed the “Start/Pause”
pushbutton and you want to change or cancel the
delayed start, proceed as follows :
• To cancel the delay start and start the cycle im-

mediately, press “Start/Pause” and then “Delay
start”. Press “Start/Pause” to start the cycle.

• To change the timer delay period, you must go

through the “Stop” position 

 and reprog-

ramme your cycle.

The lid will be locked during the delayed start time.
If you need to open it, you must first pause the ap-
pliance by pressing the “Start/Pause” pushbutton.
After closing the lid again, press the “Start/Pause”
pushbutton.

 electrolux

Summary of Contents for EWT 9120 W













Reviews: