3.
4.
90˚
11.7
Frost precautions
If the appliance is installed in an area
where the temperature can be less than 0
°C, remove the remaining water from the
inlet hose and the drain pump.
Do this procedure also when you
want to do the emergency drain.
1.
Disconnect the mains plug from the
mains socket.
2.
Close the water tap and disconnect
the water inlet hose.
3.
Disconnect the drain hose from a sink
or spigot
4.
Put the ends of the drain and inlet
hose in a container. Let the water
flow out of the hoses.
5.
Set the Drain programme and let it
operate until the end of the cycle.
6.
Turn the programme knob to Stop to
disconnect the appliance from the
power supply.
7.
Disconnect the appliance.
WARNING!
Make sure that the temperature is
more than 0 °C before you use
the appliance again.
The manufacturer is not responsi-
ble for damages caused by low
temperatures.
12.
TROUBLESHOOTING
The start of the appliance does not occur
or it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Service.
With some problems, the acoustic signals
operate. The
red
indicator
flashes
and one of the indicators comes on, to
show an alarm code:
•
- The appliance does not fill with
water.
•
- The appliance does not drain the
water.
•
- The appliance door is open or
not closed correctly. Check the door!
WARNING!
Deactivate the appliance before
you do the checks.
Problem
Possible solution
The programme does
not start.
Make sure that the mains plug is connected to the mains
socket.
Make sure that the appliance lid is closed.
16 www.electrolux.com
