• The appliance does not fill with water.
• The appliance fills with the water for a
long time.
Warning!
Disconnect the mains plug
from the mains socket.
To clean the filter:
1. Close the water tap.
2. Remove the inlet hose behind the appli-
ance.
3. Clean the filter in the valve with a stiff
brush or a towel.
4. Install again the inlet hose. Make sure
that the couplings are tight to prevent
leakages.
5. Open the water tap.
Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (5) of 'To
clean the drain pump'.
If necessary, clean the pump.
When you drain the water with the emer-
gency drain procedure, you must activate
again the drain system:
1. Put 2 litres of water in the main wash
compartment of the detergent dispens-
er.
2. Start the programme to drain the wa-
ter.
Frost precautions
If the appliance is installed in an area where
the temperature can be less than 0 °C, re-
move the remaining water from the inlet
hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Remove the water inlet hose
4. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
5. Empty the drain pump. Refer to the
emergency drain procedure
6. When the drain pump is empty, install
the inlet hose again.
Warning!
Make sure that the
temperature is more than 0 °C before
you use the appliance again.
The manufacturer is not responsible for
damages caused by low temperatures.
TROUBLESHOOTING
The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem (re-
fer to the table). If not, contact the service
centre.
Warning!
Deactivate the appliance
before you do the checks.
Problem
Possible cause
Possible solution
The appliance does not
start.
The mains plug is not connec-
ted in the mains socket.
Put in the mains plug.
The fuse in the box fuse is
damage.
Replace the fuse.
14
electrolux