Electrolux EWF1042BDWA, User Manual

Page: 32 / 84

32 www.electrolux.vn
Malfunction Possible cause Solution
Detergent over dose. Reduce the detergent
quantity or use another one.
(Refer page 23 “Detergents
Type And Quantity Of
Detergent”).
Machine unbalance. Redistribute laundry
manually in the drum and
start the spin phase again.
The laundry is not evenly distributed in
the drum.
Pause the machine and
redistribute laundry manually.
There is very little laundry in the drum. Load more laundry.
Unstable floors eg. wooden floors.
Refer to relevant paragraph
in “Positioning” section.
Machine
vibrates or
is noisy:
Cycle time
longer than
displayed:
The electronic unbalance detection
device has cut in because the laundry
is not evenly distributed in the drum.
The laundry is redistributed by
reverse rotation of the drum.
This may happen several times
before the unbalance disappears and
normal spinning can resume. If, after
10 minutes, the laundry is still not
evenly distributed in the drum, the
machine will not spin. In this case,
redistribute the load manually and
select the spin program.
Pause the machine and
redistribute laundry
manually.
Machine not installed properly. Make sure the levelling of
the appliance is correct.
Refer to “Installation”.
Transit bolts or packaging not
removed.
Make sure that the
packaging and/or the transit
bolts are removed. Refer to
“Unpacking”.
The load may be too small. Add more laundry in the
drum.
Machines based on modern technology operate very economically
using very little water without affecting performance.
Spinning
starts late
or machine
does not
spin:
Machine
makes an
unusual
noise:
Registration Data lost or damaged.
(Error Code: )
Restart machine by turn Off
and turn On again. If problem
not solved, please contact
Service Centre.
Remote
function
does not
work:
No water is
visible in
the drum:
The appliance calculated a new time according to the laundry
load.
The cycle is
shorter than
the time
displayed.