Electrolux EWF 87210 W, User Manual

Page: 9 / 28

Start the programme by pressing
button 6
To start the selected programme, press the
button
6 , the corresponding green pilot
light stops blinking. The appliance starts op-
erating and the only pilot light correspond-
ing to the running phase stays on.
To interrupt a programme which is running,
press the button
6 : the corresponding
green pilot light starts blinking.
To restart the programme from the point at
which it was interrupted, press the button
6
again . If you have chosen a delayed start,
the machine will begin the countdown.
If an incorrect option is selected, the
red pi-
lot light of the button 6 blinks 3 times.
Altering an option or a running
programme
It is possible to change some options be-
fore the programme carries them out.
Before you make any change, you must
PAUSE the appliance by pressing the but-
ton
6 .
Changing a running programme is possible
only by resetting it. Turn the programme se-
lector dial to
O and then to the new pro-
gramme position. Start the new programme
by pressing the button
6 again. The wash-
ing water in the tub will be not emptied out.
Interrupting a programme
Press the button 6 to interrupt a pro-
gramme which is running, the correspond-
ing green pilot light starts blinking.
Press the button again to
restart the pro-
gramme.
Cancelling a programme
Turn the selector dial to to cancel a pro-
gramme which is running.
You can select now a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button
6 . After a
few minutes the light 8.2 goes out and it is
possible to open the door.
If this light remains lit and the door is
locked, this means that the machine is al-
ready heating or that the water level is too
high. In any case, do not try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
O . After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!)
.
After closing the door, it is necessary to se-
lect the programme and options again and
to press button
6 .
At the end of the programme
The machine stops automatically. The pilot
light of button
6 , the pilot lights 8.1 and
8.2 go off. The light 8.3 illuminates.
If a programme or an option that ends with
water left in the tub has been selected, the
pilot light
8.2 remains on and the door is
locked to indicate that the water must be
emptied out before opening the door.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
turning the relevant dial.
4. Press button 6 .
At the end of the programme, the light 8.2
goes off to indicate that the door can be
now opened. Turn the programme selector
dial to
O to switch the machine off.
Remove the laundry from the drum and care-
fully check that the drum is empty. If you do
not intend to carry out another wash, close
the water tap. Leave the door open to pre-
vent the formation of mildew and unpleas-
ant smells.
Stand by : once the programme has fin-
ished after a few minutes the energy sav-
ing system is enabled with the pilot
lights switched on. By pressing any but-
ton the appliance will come out of the
energy saving status.
electrolux 9