Electrolux EWF 1215, Instruction Book, Page: 14 / 21

73
ENGLISH
8. Start the programme
Depress “ Start Pause ” button, the corresponding
pilot light stops flashing and remains lit.
9. Altering an option or a programme
It is possible to change any option before the
programme carries it out.
Before you make any change, you must pause the
washing machine by pressing the “
Start Pause ”
button.
Changing a running programme is possible only by
resetting it. Turn the programme selector dial to “
O ”
and then to the new programme position. The
washing water in the tub will not emptied out.
Start the new programme by depressing the
“
Start Pause ” button.
10. Interrupting a programme
Depress the “ Start Pause ” button to interrupt a
programme which is running, the corresponding light
starts to flash. Depress the same button again to
restart the programme.
11. Cancelling a programme
Turn the selector dial to “ O” to cancel a programme
which is running.
Now you can select a new programme.
12. Opening the door after the
programme has started
First set the machine to PAUSE by pressing the
“
Start Pause ” button.
If the door does not open, this means that the water
temperature is above 55°C, that the water level is
above the bottom edge of the door or that the drum
is turning.
Start
Pause
If you cannot open the door but you need to open it
you have to switch the machine off by turning the
programme selector dial to “
O ”. After about 3
minutes the door can be opened (pay attention to
the water level and temperature!).
Select the programme again and depress “
Start
Pause ” to restart it.
13. At the end of the programme
The machine stops automatically.
The “
Start Pause ” pilot goes out and the “ End ” pilot
light comes on. The door can be opened.
If the “Rinse hold” option has been selected, the
“ End ” and (rinse hold) lights remain lit, the door
is blocked to indicate that the water must be
emptied out before opening the door.
To do this turn the programme selector dial to “ O ”
and then to programme (drain) or (spin).
The spin programme is performed at the maximum
speed. In order to avoid any creasing in synthetic,
delicate, wool and handwash items, the spin speed
must be reduced by pressing the “
Speed 1200 ”
button.
Release of the lock is also indicated by the coming
on of the “
End ” light.
Switch the machine off by turning the programme
selector dial to “
O ”.
Remove the laundry from the drum and carefully
check that the drum is empty so as to avoid any
forgotten items being damaged in a subsequent
wash (e.g. shrinking) or their colour running into a
load of whites.
If you do not intend to carry out another wash, close
the water tap.
Leave the door open to prevent the formation of
mildew and unpleasant smells.
132987420GB.qxd 13/01/2005 09:31 Pagina 73 (Nero/Process Black pellicola)