51
GB
Once defrosting is completed, dry the wet surfaces
and push back the defrost water drain.
Connect the product to the mains.
Rotate the thermostat to position <<-18°C>> and let
the product operate in quick freeze mode for at least
2 hours before putting back the formerly removed
frozen foods.
Regular cleaning
It is practical to clean the inside of the freezer and
defrost it at a time.
Household cleaner or soap must not be used.
After breaking the circuit wash the appliance using
lukewarm water and wipe it.
Clean the door gasket with clean water.
After cleaning apply voltage to the appliance.
It is recommended to remove the dust and dirt
collected on the back of the appliance and the
condenser once or twice a year.
Long-term abscence
If you do not use the product for longer periods, make
sure to perform the following:
Set the thermostat to position << >>.
Disconnect the product from the mains.
Trouble shooting
During operation of the appliance some smaller but
annoying trouble can often occur, which does not
require calling a technician out. In the following
chart information is given about them to avoid
unnecessary charges on service.
We draw your attention that operation of appliance
goes with certain sounds (compressor- and
circulating sound). This is not trouble, but means
normal operation.
We draw it to your attention again that the
appliance operates discontinuously, so the
stopping of compressor does not mean being no-
current. That is why you must not touch the
electrical parts of the appliance before removing it
from the mains socket.
Remove all foods from the product.
Perform defrosting and cleaning operations as
described above.
Leave the doors ajar to avoid the build-up of
unpleasant odors.
If you fail to remedy a problem, please contact the nearest authorized service unit.
Operation failure
When the electronic system fails to detect the ACTUAL temperature, the alarm indicator will start to flash. The
product will continue to operate with the use of a reserve system until the problem is eliminated by the local
service personnel.
Problem
Cooling is too weak.
Cooling is too strong
No cooling at all.
Noisy operation
Possible cause
Thermostat is set too low.
No sufficient pre-cooling done before freezing started.
Too large food inserted:
Too much food inserted for freezing at the same
time.
Food inserted while still hot.
Door not fully closed.
Thermostat is set too high.
Plug is not properly inserted into socket.
No current in socket.
Thermostat set to "0" position.
Product support is not correct.
Solution
Set to higher position.
Provide for sufficient pre-cooling time.
Cut food into pieces.
Insert less food.
Insert food of max. room temperature.
Check if door is fully closed.
Set to lower position.
Check plug-socket connection.
Check presence of current.
Check thermostat setting.
Check stability of product support (all four feet
should stand on floor).
