Problem
Possible cause
Solution
Water flows on the floor.
The melting water outlet
is not connected to the
evaporative tray above
the compressor.
Attach the melting water out‐
let to the evaporative tray.
Temperature cannot be
set.
The FastFreeze or Shop‐
ping mode is switched
on.
Switch off FastFreeze or
Shopping manually, or wait
until the function resets auto‐
matically to set the tempera‐
ture. Refer to "FastFreeze or
Shopping mode".
DEMO appears on the dis‐
play.
The appliance is in dem‐
onstration mode.
Keep the Mode pressed for
approximately 10 seconds
until a long sound is heard
and display shuts off for a
short time.
The temperature in the ap‐
pliance is too low/too high.
The temperature regula‐
tor is not set correctly.
Set a higher/lower tempera‐
ture.
The food products' tem‐
perature is too high.
Let the food products tem‐
perature decrease to room
temperature before storage.
The door has been
opened often.
Open the door only if neces‐
sary.
There is no cold air circu‐
lation in the appliance.
Make sure that there is cold
air circulation in the appli‐
ance.
If the advice does not lead to
the desired result, contact
the nearest Authorised
Service Centre.
8.2 Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".
3. If necessary, replace the defective
door gaskets. Contact the Authorised
Service Centre.
9. INSTALLATION
9.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
Climate
class
Ambient temperature
SN
+10°C to + 32°C
N
+16°C to + 32°C
ST
+16°C to + 38°C
www.electrolux.com
12
Summary of Contents for EUN2244AOW
Page 58: ...www electrolux com 58 ...
Page 59: ...DEUTSCH 59 ...
