Electrolux ESS67300SW, User Manual

Page: 22 / 28

Problem and alarm code Possible cause and solution
The appliance does not
drain the water.
The display shows i20.
• Make sure that the sink spigot is not clogged.
• Make sure that the interior filter system is not clog‐
ged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows i30.
• Close the water tap.
• Make sure that the appliance is correctly installed.
• Make sure the baskets are loaded as instructed in
the user manual.
Malfunction of the water
level detection sensor.
The display shows i41 -
i44.
• Make sure that the filters are clean.
• Switch the appliance off and on.
Malfunction of the wash
pump or the drain pump.
The display shows i51 -
i59 or i5A - i5F.
• Switch the appliance off and on.
The temperature of the wa‐
ter inside the appliance is
too high or malfunction of
the temperature sensor oc‐
curred.
The display shows i61 or
i69.
• Make sure that the temperature of the inlet water
does not exceed 60°C.
• Switch the appliance off and on.
Technical malfunction of
the appliance.
The display shows iC0 or
iC3.
• Switch the appliance off and on.
The level of water inside
the appliance is too high.
The display shows iF1.
• Switch the appliance off and on.
• Make sure that the filters are clean.
• Make sure that the outlet hose is installed at the right
height above the floor. Refer to the installation in‐
structions.
The appliance stops and
starts more times during
operation.
• It is normal. It provides optimal cleaning results and
energy savings.
The programme lasts too
long.
• If the delay start option is set, cancel the delay set‐
ting or wait for the end of the countdown.
• Activate the TimeManager option to reduce the pro‐
gramme duration.
• Activating options can increase the programme dura‐
tion.
The displayed programme
duration is different than
the duration in the con‐
sumption values table.
• Refer to the consumption values table in the chapter
"Programmes".
www.electrolux.com 22