25
If the program won’t start
• Check if the plug is connected.
• Check your indoor fuses.
• Be sure that the water inlet tap is turned on.
• Be sure that you have closed the machine door.
• Be sure that you switched off the machine by
pressing the Power On / Off button.
• Be sure that the water inlet filter and the machine
filters are not clogged.
If detergent residues are left in the detergent
compartment
• Detergent has been added when the detergent
compartment was wet.
If water is left inside the machine at the end of the
program
• The water drain hose is clogged or twisted.
• The filters are clogged.
• The program is not finished yet.
If the machine stops during a wash operation
• Power failure.
• Water inlet failure.
• Program can be on standby mode.
If shaking and hitting noises are heard during a
wash operation
• Dishes placed incorrectly.
• Spray arm hitting the dishes.
If there are partial food wastes left on the dishes
• Dishes placed incorrectly into the machine, sprayed
water did not reach related places.
• Basket overly loaded.
• Dishes leaning against one another.
• Very small amount of detergent added.
• An unsuitable, rather weak wash program selected.
• Spray arm clogged with food wastes.
• Filters clogged.
• Filters incorrectly fitted.
• Water drain pump clogged.
If there are whitish stains on the dishes
• A very small amount of detergent is being used.
• Rinse aid dosage setting at a very low level.
• A detergent without phosphate used; try one that
contains phosphate.
If the dishes are not dry
• A program without a dry operation selected.
• Rinse aid dosage set too low
• Dishes unloaded too soon
If there are rust stains on the dishes
• Stainless-steel quality of the dishes washed is not
dishwasher grade.
• High level of salt in the wash water.
• Poor mains grounding.
If the ‘Turn on the Tap’ warning shows during
operation
When you see “Turn on the tap” warning;
• Make sure water is not cut off.
• Make sure the tap is turned on.
• Call the authorised service if there is water and the
tap is turned on.
Call an Authorised Service Centre if the problem still
persists after the controls or in case of any malfunction
not described above.
When you see the messages above, error codes are
stated before definitions. You can find these details on
page 27 of your manual.