Electrolux ESF65050, User Manual

Page: 18 / 24

If a repair is necessary, the appliance must
be easily accessible for the engineer. Install
the appliance worktop to the appliance if
you want to use the dishwasher as a free-
standing appliance.
The plinth on freestanding appliance is not
adjustable.
Adjusting the level of the appliance
Make sure that the appliance is level to
close and seal the door correctly. If the level
of the appliance is correct, the door does
not catch on the sides of the cabinet. If the
door does not close correctly, loosen or
tighten the adjustable feet until the appli-
ance is level.
WATER CONNECTION
Water inlet hose
Connected the appliance to a hot (max.
60°) or cold water supply.
If the hot water comes from alternative
sources of energy that are more environ-
mentally friendly (e.g. solar or photovoltaic
panels and aeolian), use a hot water supply
to decrease energy consumption.
Connect the inlet hose to a water tap with
an external thread of 3/4”.
Caution! Do not use connection hoses
from an old appliance.
The water pressure must be in the limits (re-
fer to 'Technical data'). Make sure that the
local water authority gives you the average
mains pressure in your area.
Make sure that there are no kinks in the
water inlet hose and that the water inlet
hose is not squashed or entangled.
Fit the locknut correctly to prevent water
leaks.
Caution! Do not connect the appliance
to new pipes or pipes that are not used
for a long time. Let the water run for
some minutes, then connect the inlet
hose.
The water inlet hose is double-walled and
has an inner mains cable and a safety valve.
The water inlet hose is under pressure only
while the water is running. If there is a leak
in the water inlet hose, the safety valve in-
terrupts the running water.
Be careful when you connect the water inlet
hose:
• Do not put the water inlet hose or the
safety valve in water.
• If the water inlet hose or the safety valve
is damaged, immediately disconnect the
mains plug from the mains socket.
• Only let the Service Force Centre replace
the water inlet hose with safety valve.
Warning! Dangerous voltage
Water drain hose
1. Connect the water drain hose to the
sink spigot and attach it under the work
surface. This prevents that the waste
water from the sink goes back into the
appliance.
2. Connect the water drain hose to a
stand pipe with vent-hole (minimum in-
ternal diameter 4 cm).
max 85 cm
min 40 cm
max 400 cm
Make sure that the drain hose is not bent or
squashed to prevent that the water drains
does not drain correctly.
18 electrolux