INSTALLATION
PIN09GB
4
Remove all packaging before positioning the
machine.
Positioning
If possible, position the machine next to a water tap
and a drain.
The sides and the back of the dishwasher can rest
against the adjacent furniture or the wall.
The dishwasher features fill and drain hoses which
can be turned either to the left or the right to suit the
installation.
Levelling
Good levelling is essential for correct closure and
sealing of the door.
If the door does not close correctly, loosen or tighten
the adjustable support feet, until the machine is
perfectly level.
Adjusting the Worktop
You can move the worktop forward or backward by 25
mm in order to align the machine with other kitchen
units.
Simply unscrew the two front retaining screws, move
the top to the required position and then retighten the
screws.
Installing and Securing the Machine Under
a Kitchen Unit (Sink-Worktop Unit)
By removing the machine's worktop, you can install it
under a close fitting sink unit or a pre-existing top, if
the dimensions of the recess correspond to those
shown in the picture.
Then proceed as follows:
Remove the machine worktop by unscrewing the two
front retaining screws, pull from the front and slide out
the rear slots, lifting the worktop.
Insert the machine after adjusting the height and level-
ling with the adjustable feet. When inserting the ma-
chine, ensure that the water inlet and drain hoses are
not kinked or squashed.
Caution
Once the machine has been installed, ensure that it
can be accessed easily for servicing.
Fitting a decor panel on the door
The door of this machine has frames for fitting a plastic
laminate decor panel in the colour required to match the
dishwasher with the rest of the kitchen furniture. If you
wish to do this you must provide the panel yourself.
Width:
588 mm
Height:
586 mm
Max thickness:
4 mm
To fit the panel
Take the door frame off removing the retaining screws
around the edge.
Position the panel, refit the frame and tighten the re-
taining screws around the edge.
Note:
The panel should be fitted before positioning the machine.
IN01
IN03
820
570
÷
600
600
IN05
AP01
