23
INSTALLATION AND CONNECTION
INSTRUCTIONS
Installing the Dishwasher
•
The dishwasher must be installed on a firm floor
and adjusted to ensure that it is stable and level.
•
To compensate for unevenness in the floor and to
match the height of the appliance to that of sur-
rounding units extend the threaded feet by
unscrewing :
– use a screwdriver.
•
For built-in, integrated and fully integrated dish-
washers, the rear feet should be adjusted from the
front of the appliance using a screwdriver.
•
The drain hose, inlet hose and mains cable must
not be kinked or crushed when the dishwasher is
in position.
•
The dishwasher must also be screwed on tightly to
the work surface or to the adjoining units. This is
essential to ensure the diswasher does not tip.
Depending on type, the dishwasher is to be installed as follows:
Dishwashers That Can Be Inte-
grated
(see installation template supplied)
3
The door of the appliance can be fitted with a
wooden furniture door with the following
dimensions
1
If the facing panel is longer than 600 mm, the
door of the appliance cannot be opened
completely (the facing panel bumps against
the plinth).
If this is the case, the plinth must be cut out
(see installation template) or the brace
adapter for the extra long door BLT 60 must
be used. You can obtain this with the E No.
911 239 008.
Width:
591 – 594 mm
Thickness:
16 – 24 mm
Height:
(variable)
dependent on
- Recess height
- Plinth height
- The adjustment so that the unit matches the height
of the adjoining units
The exact height of the adjoining units must be
measured at the place of installation.
Weight:
max. 8 kg
Summary of Contents for ESF 631
Page 1: ...D i s h w a s h e r User Instructions ANC 822 945 701 00 0102 ESF 631 EN ...
Page 29: ...29 ...
Page 30: ...30 ...
Page 32: ......
