Electrolux ESF 63025, User Manual

Page: 32 / 40

the water fill and drain hose and power
supply cable pass through.
Leave a space of 2 mm between the top
of the dishwasher and the underside of
the kitchen counter.
During all operations that involve
accessibility to internal components the
dishwasher has to be unplugged.
When inserting the machine, ensure that
the water inlet hose, the drain hose and
the supply cable are not kinked or
squashed.
Adjusting the height of the
dishwasher
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable
plinth.
3. Adjust the rear foot by turning the
screw in the middle of the front kick
plate to the left or to the right. Good
levelling is essential for correct clo-
sure and sealing of the door.
When the appliance is correctly lev-
elled, the door will not catch on the
levelling spacers on either side of
the cabinet. If the door does not
close properly, loosen or tighten the
adjustable feet until the machine is
perfectly level.
Adjusting the height of the plinth
It is important for the dishwasher to be
absolutely horizontal so that the door
seals properly. The adjustable feet are to
be turned to the left or right until the
dishwasher is horizontal. If there is a
space at the bottom of the machine, this
can be covered by lowering the plinth.
Fitting the vapour protection
600 mm
Fit the adhesive protection foil onto the
front part of the worktop, along the entire
width.
Fixing to the adjacent units
32 electrolux installation