Electrolux ESF 43020, User Manual

Page: 34 / 76

Do these steps to remove the appliance
worktop:
1. Remove the rear screws (1).
2. Pull the worktop from the behind the ap-
pliance (2).
3. Lift the worktop and move it from the front
slots (3).
4. Use the adjustable feet to adjust the level
of the appliance.
5. Install the appliance under the kitchen
worktop. Make sure that there are no
kinks in the water hoses and that the wa-
ter hoses are not squashed.
If a repair is necessary, the appliance must
be easily accessible for the engineer. Install
the appliance worktop to the appliance if you
want to use the dishwasher as a freestanding
appliance.
The plinth on freestanding appliance is not
adjustable.
Adjusting the level of the appliance
Make sure that the appliance is level to close
and seal the door correctly. If the level of the
appliance is correct, the door does not catch
on the sides of the cabinet. If the door does
not close correctly, loosen or tighten the ad-
justable feet until the appliance is level.
Water connection
Water inlet hose
Connected the appliance to a hot (max. 60°)
or cold water supply.
If the hot water comes from alternative sour-
ces of energy that are more environmentally
friendly (e.g. solar or photovoltaic panels and
aeolian), use a hot water supply to decrease
energy consumption.
Connect the inlet hose to a water tap with an
external thread of 3/4”.
Caution! Do not use connection hoses
from an old appliance.
The water pressure must be in the limits (refer
to 'Technical data'). Make sure that the local
water authority gives you the average mains
pressure in your area.
Make sure that there are no kinks in the water
inlet hose and that the water inlet hose is not
squashed or entangled.
Fit the locknut correctly to prevent water
leaks.
Caution! Do not connect the appliance
to new pipes or pipes that are not used
for a long time. Let the water run for
some minutes, then connect the inlet
hose.
The water inlet hose is double-walled and
has an inner mains cable and a safety valve.
The water inlet hose is under pressure only
while the water is running. If there is a leak in
the water inlet hose, the safety valve inter-
rupts the running water.
Be careful when you connect the water inlet
hose:
• Do not put the water inlet hose or the safe-
ty valve in water.
• If the water inlet hose or the safety valve is
damaged, immediately disconnect the
mains plug from the mains socket.
• Only let the Service Force Centre replace
the water inlet hose with safety valve.
34 electrolux