Electrolux ERI522DSD, User Manual

Page: 8 / 16

8 electrolux.com.au
MAINTENANCE
CLEANING
WARNING
Before performing any maintenance operation, isolate
the hood from the electrical supply by switching off at
the connector and removing the connector fuse. Or if the
appliance has been connected through a plug and socket,
then the plug must be removed from the socket.
The cooker hood should be cleaned regularly (at least with
the same frequency with which you carry out maintenance
of the fat filters) internally and externally. Do not use
abrasive products. Do not use alcohol!
WARNING
Failure to carry out the basic cleaning recommendations
of the cooker hood and replacement of the filters may
cause fire risks. Therefore, we recommend observing
these instructions.
The manufacturer declines all responsibility for any
damage to the motor or any fire damage linked to
inappropriate maintenance or failure to observe the
above safety recommendations.
Cooker hood
Clean the cooker hood with soapy water and a soft cloth.
Then wipe with clean water to rinse. Do not use aggressive
cleaning agents such as soda. The cooker hood paintwork
will stay looking nice if you wax it occasionally.
Stainless steel canopy hoods
Do not use any sort of scourer. Treat with a stainless
steel care product and polish with the structure of the
stainless steel.
Metal grease filters
These must be cleaned once a month (or when the
filter saturation indication system – if envisaged on the
model in possession – indicates this necessity) using non
aggressive detergents, either by hand or in the dishwasher,
which must be set to a low temperature and a short cycle.
The openings must be placed downwards to let the water
run out of the filters. The cleaning agents will make the
aluminium filter turn dull, this is normal.
LIGHTING
Changing the light bulbs
Faulty LEDs must be replaced by a professional installer.
GREASE FILTERS
Removing the grease filters
Switch off the electricity! Remove the plug from the socket
or switch the electricity off at the mains. Open the panel
and pull the special handle to remove the filter.
Replacing the carbon filter
The carbon filter must always be used if the cooker hood
is not ducted.
NOTE: It is not recommended to fit a carbon filter when the
cooker hood is installed with ducting.
1. Open the panel.
2. Remove the grease filters.
3. Fit the carbon filter by wedging it into the casing (D).
4. Replace the filter grids in the extractor hood.
NOTE:
• Saturation of the activated charcoal will eventually
occur after prolonged use, depending on the type of
cooking and how frequently the grease filter is cleaned.
• In all cases it is necessary to replace the cartridge at
least every four months.
• DO NOT wash or reuse the carbon filter. Saturated
carbon is not environmentally friendly, change the
filter regularly.