Electrolux ERA37520W, User Manual

Page: 11 / 16

Problem Possible cause Solution
The buzzer sounds. The
Alarm icon flashing. The door is not closed correctly. Refer to "Door open alarm".
upper or lower square
is shown in the tempera-
ture display.
An error has occurred in meas-
uring the temperature Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible)
The compressor runs
continuously. The Temperature regulator may
be set incorrectly. Set a warmer temperature.
The door is not closed correctly. Refer to "Closing the door".
The door has been opened too
frequently. Do not keep the door open longer
than necessary.
The food temperature is too
high. Let the food temperature de-
crease to room temperature be-
fore storage.
The room temperature is too
high. Decrease the room temperature.
Water flows inside the
refrigerator. The water outlet is clogged. Clean the water outlet.
Food prevent that water flows
into the water collector. Make sure that food do not touch
the rear plate.
Water flows on the
ground. The melting water outlet does
not flow in the evaporative tray
above the compressor. Attach the melting water outlet to
the evaporative tray.
The temperature in the
appliance is too cold. The Temperature regulator may
be set incorrectly. Set a warmer temperature.
The temperature in the
appliance is too warm. The Temperature regulator may
be set incorrectly. Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The food temperature is too
high. Let the food temperature de-
crease to room temperature be-
fore storage.
The temperature in the
refrigerator is too warm. There is no cold air circulation in
the appliance. Make sure that there is cold air
circulation in the appliance.
Large quantities of food to be
cooled were put in at the same
time. Insert smaller quantities of food to
be cooled at the same time.
The appliance does not
operate. The appliance is switched off. Switch on the appliance.
The mains plug is not connected
to the mains socket correctly. Connect the mains plug to the
mains socket correctly.
The appliance has no power.
There is no voltage in the mains
socket. Connect a another electrical ap-
pliance to the mains socket.
Check fuse. Contact a qualified
electrician.
The lamp does not work. The lamp is defective. Refer to "Replacing the lamp".
The door has been open to long. Close the door.
electrolux 11